Infinity USB Foot Pedal (IN-USB-3)

FPVECUSB - Setup Instructions

• Infinity USB Foot Pedal (IN-USB-3) - FAQ
• Infinity USB Foot Pedal (IN-USB-3) - Support

Setting up the FPVECUSB Infinity Foot Pedal for Express Scribe is easy. For Windows computers, just follow the instructions below.

These instructions are for Express Scribe v5.40 and later.

1. Download and install Express Scribe.
2. Plug in the foot pedal to an available USB port on your computer.
3. Click on 'Options' in the Express Scribe toolbar in the main window, then select the 'Pedals' tab.
4. Tick the option 'Enable foot pedal controller'.
5. Click on 'Controller setup wizard...', then click Next. Select your controller from the list of detected controllers, then click 'Next'.
6. Click 'Next' again to confirm your controller.
7. On the next screen you can custom configure your controller. To do so, left-click on any command in the window. A drop-down list will appear. Select your desired command from the list.
8. On the same screen you can also press down the pedals on your controller to test that they are operational.
9. When you are done, click the 'Finish' button to complete the wizard.

For Mac OS X version of Express Scribe v5.40 and later - See the above instructions.

For Mac OS X version of Express Scribe 5 and earlier - just plug them into the USB socket and run Express Scribe and they will be detected normally. Otherwise, you can also go into the Preferences -> Controller tab and run the foot pedal configuration tool.